Why does F10 (continue) in Visual Studio not work?


I'm debugging a (web) project in Visual Studio 2008. It is breaking and the first break point only, and thereafter when i hit F10 it ignores and subsequent break points and runs all the way through. Why is this happening? Couple of pointers before we discuss the solution

  • I have tried 'clean solution'.
  • Other breakpoints sometimes(!) skipped, even in the same method
  • Make sure that you're in Debug mode not in Release.
  • There could be an exception while executing the instruction in question. Try enabling all exceptions to break into debugger and check.

The solution may be:

Tools -> Options -> Debugging -> General -> Un-check off Enable Just My Code.

Print | posted @ Thursday, September 10, 2009 1:58 PM

Comments on this entry:

Gravatar # re: Why does F10 (continue) in Visual Studio 2012 not work?
by prashnat Tyagi at 7/8/2014 3:56 AM

facing the problem regarding the vsiual studio 2012 debugaar mode in not working f10 key was not working
m using the window8.1 64 bit
Post A Comment